Roof edge trims Anthracite Aluminium Inner corner 6.0 x 6.4 x 40 cm - Per Piece

For finishing the inside corners of your flat roofs, Wovar 6 x 6.4 cm Corner profiles. The Corner profiles have a nice Anthracite colour and are ideal for finishing roofs with EPDM foil, roofing leather or easyroofing. Make use of our A2 stainless steel self-tapping screws which allow you to screw the roof edge trims easily and in a durable way.

We recommend using Stainless steel screws to avoid corrosion and rust spots on your finish. Sometimes screws can slip if you just try to screw them into the corner profile. We therefore recommend using a 3 mm drill bit to pre-drill a hole to prevent this. You will need two screws for each side of the inner corner for a secure mounting. 

In addition, at Wovar we also have roof edge trims 250 cm long in the range. If you want to connect the corners to straight Aluminium roof edge trims, you should use our couplers. These are not included in this product and must be ordered in addition. Couplers are sliding plates with which you can easily connect the different elements roof edge trims to each other.

How to fasten an inside corner roof edge trimming

Ordering Anthracite inner corner

For roof edge trims inside corners of anthracite, Wovar is the right place. Is this not quite the size you are looking for, or are you for example looking for exterior corners? Then take a look at our entire range on the category page aluminium profiles.