Zinc bend (67°)

Every gutter should be connected to your drain so that the water is neatly transported from the roof, via the gutter and downpipe, to your drain. To achieve this, apart from an outlet to transport the water from your gutter to the downpipe, you also have 3 bends per downpipe. These bends ensure that the water connects perfectly to your downpipe via the spout while you can install the downpipe on the wall of your garden shed, Roofs, Carports or house and to ensure that the water can be drained into the drain at the bottom.

These zinc bends fit our spout and are suitable for a downpipe with a diameter of 87 mm. The bends are set at a 67-degree angle and can be easily installed without glue or other fasteners. The first one you slide over the bottom of the outlet with the bend towards the wall of your garden shed, the second one you slide over the bend at the bottom with the bend pointing downwards. Finally, slide your downpipe into this (securing it with the correct brackets) and finally slide the last bend over the downpipe with the bend away from the wall. Thanks to the useful clamping system, it is immediately secure and you do not need any further fasteners.

Necessary parts gutter

A gutter consists of various parts, exactly what you need and how many of each depends on the type of roof (pent roof, gable roof, quadrangle) and the length of the roof. So Construction companies, gardeners and other handymen benefit from an extra discount and have access to a useful order overview.

If you would rather have a PVC gutter, please check our zinc gutter category for the right accessories. For other gutter accessories, take a look at the gutters, where you can find, among other things, bold wire grids and other useful accessories.

Do not forget to look at the gutters.